Asymod IIIs, Руководство по установке

Страница: 18 / 57

- 18 -
NOTE:
IMPORTANT
Keep in mind that the transceiver is only the exciter and should not be expected to generate high levels
of RF power, it should be expected, however, to generate a clean, perfect modulated wide-band audio
signal that can be later amplified with a class C, RF power amplifier to the desired level. It is highly
recommended to use dual final transceiver which allow for plenty of headroom and much cooler
operation.

For single final transceivers, such as the Cobra 29s & 25s, Galaxy DX-2547, DX-919, DX-959, etc.,
both RF driver and RF final must be modulated to achieve maximum modulation. Typically a .75
watt carrier with peaks of 10 watts pr300% modulation levels. This configuration puts a
greater load on the DC/DC converter as opposed to dual final transceivers where only the RF
driver is modulated.

For dual final transceivers (recommended), such as Galaxy DX-2527, DX- 98VHP, etc., only the
driver is modulated and the dual finals are fed +12 volts. This configuration offers plenty of
headroom and puts far less stress and less of a load on the DC/DC converter and allows for
higher RF output levels.
Cobra Section