ASTRO U 149 S, Руководство по эксплуатации, Страница: 24 / 52

“Input Settings” menu
Operating manual U 149 S - Version 08-2015A page 24
“Input Settings” menu
To have the reception settings for the four SAT inputs of the U 149 S displayed, click on the item “Input
settings” in the menu at the left.
LNB and DiSEqC settings
Settings for the supply unit used can be entered in the upper “Configuration” table.
Figure 24: “Configuration” table
The following parameters can be configured here:

LNC Type:
Select the LNB type being used from the drop-down menu (Universal or Quattro
switch). If you use an LNB with a different LO frequency, select the item “LO = manual input”.

Voltage Vertical:
Select the LNB voltage for vertical polarisation (this is used when the
“Voltage” parameter in the “Input Settings” table is set to “auto”).

Voltage Horizontal:
Select the LNB voltage for horizontal polarisation (this is used when the
“Voltage” parameter in the “Input Settings” table is set to “auto”).

DiSEqC:
If you are using a reception unit with a DiSEqC controller, activate the corresponding
radio button for the version supported here. If no DiSEqC
controller is being used, activate the radio button “off”.
If you change the activation or deactivation status of inputs or outputs in one of the two tables, then
click on the “Submit” button below the last table to save your changes. Click on “Reset form” to restore
the original settings.
Satellite settings
You can enter settings for selecting the satellites received in the “Input Settings” table.
Figure 25: “Input Settings” table