ASTRO U 149 S, Руководство по эксплуатации, Страница: 20 / 52

“Main” menu
Operating manual U 149 S - Version 08-2015A page 20
“Main” menu
This section explains how to enter general settings for the interfaces and the management of the U 149
S.
Click on the item “Main” in the menu at the left.
Setting the IP interfaces
You can configure IP interfaces and activate or deactivate them using the upper table (“IP interface set-
tings”). The connection type is automatically identified and displayed by the U 149 S (in this case: 1
GBit/s, full duplex).
HINWEIS
:
In order to make changes in this table, you must be logged in as the adminis-
trator.
Figure 19: Configuring IP interfaces
The following parameters are displayed, and can be configured:

MAC:
MAC address of the respective interface

Active:
Activate the radio button “on” to activate the interface. Activate the radio button “off” to
deactivate the interface.

Mode:
Connection type (identified automatically)

Address:
IP address

Subnet:
Netmask

Broadcast:
Broadcast address

Gateway:
Gateway IP (if required)
HINWEIS
:
When programming the IP addresses, make sure the addresses have not already
been allocated within your network. Address conflicts result in network malfunctions. (Please
set unused parameters to 0.0.0.0.)
To save your changes, click on the “Submit” button below the last table.
Configuring management settings
You can configure the following management settings in the second table (“IP management settings”):
Figure 20: Configuring management settings