ASTRO astrojet II plus, Инструкция по установке и эксплуатации

Страница: 11 / 62

7
Section 3 –
Installation and Setup
Before using the AstroJet Image Blaster Printer for the first time, the following
procedures must be performed:
•
Choose a location for the AstroJet Image Blaster system
•
Install the Image Blaster on the base unit
•
Install the Encoder in the base unit
•
Installing the inkjet cartridges
•
Plug in the AstroJet Image Blaster
•
Connect the AstroJet Image Blaster to the computer
•
Install the AstroJet software
•
Adjust for media thickness
•
Position the printed output on the media
Choosing a Location
Ø
The AstroJet Image Blaster Printer should be installed on the feeder base
and attached to your computer with a printer cable not more than 6 feet in
length.
Ø
Use a grounded electrical outlet. DO NOT USE AN ADAPTER PLUG!
Ø
Do not use outlets that are controlled by wall switches.
Ø
Do not use an outlet that shares the same circuit with large electrical
machines or appliances.
Ø
Protect the AstroJet Image Blaster from excessive heat, dust, and
moisture – avoid placing the system in direct sunlight.
Installing Image Blaster on Base
A template and two (2) 123-0182 1/4-20 bolts 3/4 inch long and two (2) 123-211 1/4-20
bolts 1-1/4 inch long, (2) 23-102-30 studs, and (2) 23-102-35 eccentric studs are packed
with the Image Blaster. The template pictured below is used to locate the position of the
four mounting holes of the Image Blaster on the base unit. This is done in the following
manner:
1. Disconnect the base unit from the power supply.
2. Locate the 23-100-35 template over an area of the base units’ transport belts.
The cutout in the template is the total available area that the print heads on
the Image Blaster can print in. Make sure that there are no rollers or other
obstructions in this area on the base.
3. With the front (thin end) of the template facing toward the front and
perpendicular to the direction of travel of the transport belts, mark the four
holes on the base. Use a square to make sure that the cutout in the template
is perpendicular to the transport belts.