Operation
900912-00C, 04/2019
Innovative Hearth Products
Gemini™ -C Series Direct-Vent Gas Fireplaces
58
Figure 43 - Install left bottom log (3)
Figure 44 - Install left twig log (4)
Figure 45 - Install right twig log (5)
Figure 46 - Install glowing embers (rockwool)
Do NOT place embers on or
close to large ports or the pilot
area as seen here.
NOTE: Enough glowing ember material is provided for several applications.
For best glowing effect, replace the ember material annually.
Holes
Bottom View
Bottom View
Top View
Top View
Hole
5
Bottom View
Top View
Glowing Embers
Holes
Installing the Gemini-C 35/40 Series Log Set
(continued)
5. Install the holes on left bottom log (3) (
Figure 43
) onto the two pins on log 2 (
Figure 42
).
6. Install the hole on left twig log (4) (
Figure 44
) onto the pin on log 1 (
Figure 41
) as follows - Place log on top pin in rear log (1) first
than slide the arched portion so it rests on the lower left hand grate finger (
Figure 40
).
NOTE
: The left bottom log may need to be
adjusted toward the rear of the unit to allow this log to fit properly.
3
2
4
1
7. Install the holes on right twig log (5) (
Figure 45
) and onto the pin on rear log (1) (
Figure 41
) and the pin on bottom right log (2)
(
Figure 42
).
8. Tear the glowing embers into dime size pieces. Place glowing embers as shown in
Figure 46
.
2
1
NOTE
: Log set should be in the upright position after installation.
No flame impingement should occur on rear log.
f i r e - p a r t s . c o m
