www.Astria.US.com
126891-01A
11
OPERATION
Continued
4. Wait five (5) minutes to clear out any gas.
If you then smell gas STOP! Follow the
safety information, page 10. If you don't
smell gas, go on to the next step.
5. Turn PilotStat knob to PILOT. Push in on
PilotStat knob and press Piezo button
until the pilot is lit.
6. Continue to hold PilotStat knob in until
LED blinks (one brief blink every two
seconds) then release knob.
Note: You will need to hold the knob in for
about one minute.
7. Turn PilotStat knob to ON See Figure 12,
page 10.
WARNING: Moving the Lo
-
cal/Remote switch can cause
the main burner to come on
immediately. Stand away from
the main burner when moving
the local/remote switch to avoid
possible injury.
USING TRANSMITTER/
REMOTE
1. Place 3 AAA batteries in remote. (page 12)
2. Move switch to REMOTE position (see
Figure 12, page 10). Remote comes on
in Manual mode.
3. Press FLAME key on remote within 30
seconds.
4. Make sure LED display turns on for one
second.
Figure 13 - Correct Pilot Flame Pattern
5. Press MODE
button until mode
shows in display window of transmitter/
remote. Press up or down key to change
set temperature.
6. To set delay timer, press TIMER
button
followed by either the up or down key.
7.
To change the flame height, press the
MODE
button until mode is ON. Press
the FLAME
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
18
17
button and press the up or
down arrow key.
8. To change between Fahrenheit and Cel
-
sius, press the up and down arrow keys at
the same time and hold for at least three
seconds.
TO TURN OFF GAS
TO APPLIANCE
Shut Off Main Burner Using Remote
Press MODE
button until mode is OFF.
Pilot stays lit.
Shut Off Main Burner Without Remote
Turn PilotStat knob to PILOT. Pilot stays lit.
Shut Off Main Burner and Pilot
Turn PilotStat knob to OFF.
CAUTION: During normal
shutdown of this unit, a flash
may be observed due to the na-
ture of the burner components.
Remain clear of the unit during
the shutdown process.
INSPECTING BURNERS
Check pilot flame pattern and burner flame
patterns often.
Flames from the pilot should always be pres
-
ent when the appliance is in operation (see
Figure 13).
The flame should look similar to those in
Figure 14, page 12. The flames should look
random in appearance with the ember bed
glowing red-orange in color.
f i r e - p a r t s . c o m
