www.Astria.US.com
126891-01A
10
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: Keep flue open
when operating unit.
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted with a piezo ignitor. When
lightning the pilot, follow these instruc-
tions exactly.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
gas control knob. Never use tools. If
the knob will not push in or turn by
hand, do not try to repair it, call a quali-
fied technician. Force or attempted
repair may result in a fire.
D. Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and
any gas control which has been under
water.
LIGHTING
INSTRUCTIONS
NOTICE: During initial operation
the appliance will emit a slight
odor for an hour or two. This is
due to the "burn-in" of the inter-
nal paints and lubricants used
in manufacturing. For the first
few hours, operate the appliance
with doors and windows open to
encourage dissipation of odor.
1. STOP! Read the safety information, begin
-
ning in column 1.
2. Make sure equipment shutoff valve is fully
open.
3. Set switch in the Local position.
OPERATION
Figure 12 - RF Millivolt Valve Controls
with Transmitter/Remote
Display
TRANSMITTER/REMOTE
Up Arrow
Down Arrow
Mode
Button
Timer
Button
RECEIVER/VALVE
Piezo
PilotStat
Knob
Manual
Switch
LED
The RF Millivolt valve control used on these
appliances allows you to turn the gas log set
on or off; use a timer to automatically operate
the log set; increase or decrease flame height,
fan speed or timing. An easy-to-read display
gives you information about room temperature,
set temperature, flame height level, fan speed
level and a countdown timer, as well as a low
battery indication. Figure 12 shows the location
of the controls and indicators for the transmitter
(remote) and the receiver (valve).
Note: Fan operations are not applicable to
these Hardwood Series.
f i r e - p a r t s . c o m
