Viron Pool and Spa Heater
Page 4
For your safety – read before lighting
This appliance is equipped with an ignition device which automatically lights the burner. Do not
try to light the burner by hand.
BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS. Do not try to light any appliance. Do not touch any
electrical switch. Do not use any telephone in your building. Immediately call your gas supplier
from a neighbour’s house.
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE
DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THIS APPLIANCE
DO NO SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN
OPERATION.
NOTE – Servicing shall be carried out only by authorized personnel.
OPERATING INSTRUCTIONS
1.
STOP! Read the safety information above.
2.
Turn off electric power to appliance.
3.
This appliance is equipped with an ignition device which automatically lights the burner. Do
not try to light the burner by hand.
4.
Wait five minutes to clear out any gas. If you then smell gas, STOP! Refer to instructions
above.
5.
Turn filtration pump on.
6.
Turn on power to the heater and press the pool/spa button to select pool or spa mode.
7.
Set thermostat to desired setting and the ON/OFF switch to turn the heater ON.
8.
The heater will ignite in around 40 seconds.
9.
If the appliance will not operate, turn heater power supply off. Repeat instructions 5 to 7
above. If the appliance still does not ignite, call your service technician.
10.
For best results, your pool circulation pump should be run one consecutive period each day.
This will allow your heater to bring the pool up to temperature and reduce the gas input rate,
achieving its highest possible efficiency and lowest operating costs. Operating two or more
shorter periods each day may reduce operating cost savings.
TO TURN GAS OFF TO APPLIANCE
1.
Turn off all electrical power to the appliance.
2.
Turn off gas tap in gas line prior to heater.
