6
Mounting alarm devices
4
Before mounting the keypad and siren ensure that the system tamper is
disabled as described below.
Disabling the system tamper
Using the Keypad:
•
Press
Panic button A
and enter
pincode
(factory
default is 0000) to enter test mode, press
Panic button A
then
2
to send “Tamper Off” signal,
Then press disarm twice to quit. (The keypad led will
now stop flashing if not press disarm twice again.
The siren will beep in acknowledgement.)
Using the Keyfob:
•
Press and hold down
Arm
and
Home
buttons for 5
seconds.
(The siren will beep in acknowledgement.)
Mounting the siren
Ensure the tamper switch is fully depressed when
the siren is mounted. If there is a gap, pack with a
suitable spacing material.
Round
Siren
Base
Wall
Spring Guide
Spring compressed
firmly against wall
Sq
ua
re
S
ire
n
B
as
e
Plunger must
be pressed in
fully against
wall
Wall
1
Using the large screws and wall plugs provided,
mount on the desired wall through the 4 mounting
holes.
2
Fix the siren cover with the securing screw.
Testing whether the siren is fitted correctly:
1
Press
Arm
with the Keypad/Keyfob.
2
If there are 5 short beeps when armed, the tamper
switch is NOT fully depressed and will need to be
adjusted.
3
If there is one short beep and flash when armed,
the siren is mounted correctly and the siren
installation is complete. Disarm the system and
disable the tamper as described in the information
box above.
Mounting other devices
Find a location where the device is to be mounted,
see section “Location Planning” for suggestions.
Mounting the Keypad:
1
Drill holes into the wall using the fixing slots as a
template.
Before mounting it is important to disable the
system tamper to avoid the siren sounding an
alarm.
i
The tamper function is now disabled for one hour.
If more time is required, simply repeat the above
step.
i
Before you make the adjustment:
•
Disarm your system
using your keyfob (Press
disarm) or keypad (Press disarm followed by the
pincode).
•
Disable the system tamper
as described on
the left.
• If there is a gap between the wall and the
tamper switch mechanism pack with a suitable
spacing material.
• Once finished repeat the step 1 and 2 above.
i
Before proceeding to mount the devices
physically, it is useful to check that it is not out of
radio range by doing a simple range test. Please
ensure the system tamper is disabled.
•
Keypad:
Hold the keypad in the desired
location and arm and disarm the system.
(The siren will beep as confirmation.)
•
Help button:
To prevent an alarm being
triggered, put the siren into learn mode first
(see page 5, section 1). Hold the device in the
desired location and press the emergency
button.
(The siren should respond with a single beep.)
•
All other devices:
Hold the device in the
desired location and press the learn/test
button.
(The siren should respond with a single beep.)
When you are satisfied that the devices work
in your chosen locations, proceed with the
installation as described in the next page.
If the siren does not respond, the location may be
out of range, try alternative locations until reliable
radio contact is obtained.
i
