5
Exiting Learn mode:
•
Press the Siren Learn button to exit the learn mode
•
The PIR and Door Contact may trigger the Siren at this
point.
(Do not turn the siren power off.)
Disarming Siren:
•
Press disarm followed by 0000.
(The siren will beep and flash twice.)
Adjusting Alarm ringing duration:
• Dip switch 3 determines the alarm ringing duration
length. Switch left for 4 minutes or right for 10
minutes (default) siren duration.
Enable/disable interference detection:
• Set Dip switch 2 for interference detection. Switch
left to enable and right to disable (default).
Programming is now finished and the system is
ready to be installed.
Entering Learn mode:
• Press and hold
Siren learn button
for 1 second.
(A short beep will follow with the outside LEDs flashing once.)
Adding devices:
Keypad
(All keys should be pressed in quick succession.)
1
Press
Panic button A
and enter
pincode
(please
note that the default pincode is 0000).
(The LED will now be flashing. System is now in setting mode)
2
Press
Panic button A
and enter
8
(The keypad will confirm with two fast flashes that it is in “Siren
as master” mode.)
3
Press
Panic button A
then
1
to send learn-in
signal.
4
Press Panic button A then 2. The press disarm
twice to quit.
(The siren will beep in acknowledgment).
(The keypad LED will now stop flashing. If not, press “disarm”
twice again)
Programming the Siren-based system
(without control panel)
3
The siren is the heart of the system. All components must be recognised by the siren.
2
1
System is now in learning mode for 3 minutes.
Proceed to the following steps to add in
additional devices (20 devices maximum) within
this time period.
If device learning takes more than 3 minutes and
the learn mode expires, the siren learn button will
need to be pressed again to add more devices.
i
When any device is learnt-in, the siren will beep
once and the outside LEDs will flash once in
acknowledgement.
Remember to press any buttons and keys firmly
for 1 second to send a learn-in radio signal.
i
3a
4
5
This unit is equipped with the latest type of
radio receiver using AM radio technology. If the
system is armed any criminal attempt to interfere
detector transmissions will trigger an alarm.
If the alarm is frequently triggered by interference
there may be high levels of unusual radio signals
in your area. Some kinds of electronic equipment
can generate this kind of radio interference.
In the unlikely event of you experiencing problems
with interference, it is recommended that you
switch interference detection off.
i
ale
Y
R
1
2
3
6
5
4
7
8
9
0
Battery
cover
Coin
slot
Locked
Unlocked
Yale
PRESS
PRESS
PRESS
PRESS
PRESS
3b
