3
Unpack all the parts on a table top
The easiest way to get to know the system and get it up and running quickly is to get all the
devices and accessories programmed on a table top before locating and mounting them.
2
Siren
The siren comes in two shapes, square shaped
and round depending on the kit purchased. The
operation and programming of the sirens are
identical, only the case is different.
WARNING
The siren is very loud, be prepared! Take care not to
activate the siren tamper switch unnecessarily.
1
Remove the cover by unscrewing the single screw
located on the lid.
2
Square siren only: remove the left hand cover (not
battery compartment).
3
Move the programming switches
to Master On (switch 4) and Clear
On (switch 1).
4
Switch the power switch to on
(The 3 strobe LEDs will now flash side to side with one short
beep.)
5
Move the Clear switch to the Off
position.
PIR movement detectors
1
Pull out the plastic pull tab on the back of the PIR.
This will activate the batteries.
(A red light can be seen flashing through the lens. This will last
for 30 seconds indicating the component’s initiation. )
l
a
Y e
R
Yale
R
O
N
1
2
3
4
Clear
O
N
1
2
3
4
Normal Master
Cover screw
Learn/Test
Button
Status
LED
Battery
Compartment
4 X D cells
Fixing
screws X 4
Internal cover
screws X 4
Learn button
Power
switch
Programming
switch
ON
OFF
ON
1 2 3 4
NORMAL
