Assa Abloy Yale HSA6060, Инструкция по установке, программированию и эксплуатации

Страница: 7 / 16

7
2 Fit wall plugs into the wall and fix cradle with the
screws provided.
Fixing Slots X 2
Keypad
Cradle Open
3 Slide the keypad into the cradle
4 Close the cradle cover so the logo is facing you
Mounting the PIR
1 Open the PIR by loosening the bottom screw.
Knock out the relevant holes on the base where
the plastic is thinner. The center two knockout
holes are for flat wall mounting while the 4 side
holes are for corner mounting.
Corner fixing
knockouts X 4
Wall fixing
knockouts X 2
2 Drill holes into the wall using the knockout holes on
the base as a template.
3 Fit wall plugs and secure the PIR base with the
screws provided.
4 Fit the PIR back together and tighten bottom
screw, the PIR installation is complete.
Mounting the door/window contact
Frame
Door/Window
Gap no more
than 8mm
Magnet
Sensor
1 Find a location where the door/window contact
is to be mounted. It should be mounted between
the door/window frame and the door/window as
shown at the top of the opening. The magnet is to
go on the door/window while the sensor is to be
placed on the frame. Windows can be protected
in a similar way to doors. Make sure the tamper
switch spring is fully depressed.
-Mounting using adhesive pads
1
Clean the mounting surface with a suitable
degreaser agent.
2 Remove the protective film from one side of the
adhesive pad and apply to the back of the sensor
and magnet
3 Remove the remaining protective film and firmly
press into place.
4 Test sensor by pressing the test button and
opening and closing the door/window. The LED
should light when the door/window is opened.
Installation is complete.
The PIRs have a built-in sleep timer to save
battery power. If there is no movement in front
of the PIRs for 1 minute, the PIRs will become
‘ready to signal’ and movement will now be
reported. The PIRs will sleep for 1 minute after
reporting.
Any movement detected in sleep time will not be
reported and will extend the sleep period by a
further 1 minute.
i
The gap between the magnet and sensor should
be approximately 10mm when closed (depending
upon the actual environment).
Simple test to see whether the magnet is in range
of the sensor: hold the magnet and sensor in
place and then pull them apart. If the sensor LED
lights up it implies the two items are within range.
i
Gap approx 10mm