6
Copyright © 2012, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
8/05/12
PR100 Exit Devices
A. Verify Hand and Bevel of Door
•
This device is non-handed.
•
Door should be fitted and hung.
•
Verify box label for size of exit device and function.
Lock Installation
1 Prepare Door
B. Door Preparation
If using a mullion, install prior to installing hardware.
Prior to installation, all holes must be free of burrs, debris and sharp edges.
Doors should be pre-prepped.
Prep door using the following (see website www.intelligentopenings.com):
•
Exit installation instructions A6770
•
Field Template A7992 (shipped with product)
•
Door Manufacturer’s Template: 4640
Inside
Outside
Left Hand
Reverse Bevel
LHRB
Right Hand
Reverse Bevel
RHRB
Fig. 1
2 Position Trim (ET)
For exterior applications, use ET gasket (52-0263) to seal
between ET escutcheon and outside door surface (Fig. 2).
1A. For wood doors: Route ET wire harness through the
cylinder hole and out the other side.
1B. For metal doors: Route ET wire harness
through the cylinder hole and door
and out the 1” diameter cutout.
2. Place ET trim on door.
3. Connector from ET harness connects
to connector from chassis (Fig. 2).
Fig. 2
3
1
ET gasket
(part number
52-0263)
Outside of Door
2
Cylinder Hole
Lever-Handle Hole
