Assa Abloy Sargent Passport 1000 PG, Руководство по установке

Страница: 8 / 24

8
1-800-727-5477 • www.sargentlock.com
A7807D 12/22
Passport 1000 PG
Mortise Lock
Copyright © 2012, 2022, SARGENT Manufacturing Company. All rights reserved.
Reproduction in whole or in part without the express written permission of SARGENT Manufacturing
Company is prohibited. Patent pending and/or patent www.assaabloydss.com/patents.
The lock body sticker states the following:
1. Ensure the handing is correct. (To change handing, see
Installation Instructions - Change Hand of Lock Body.)
2. Insert lock body in door.
3. Press wire harness through sticker.
1. Peel back the sticker that covers the retaining
ring and remove the retaining ring.
2. Orient the plastic retaining ring so that the
word BOTTOM is located at the bottom of the
cylinder hole (Figure 7A1).
3. Route the wires from the top of the cylinder
hole into the slot on the top of the plastic
retaining ring, NOT through the retaining ring
(Figure 7A2) and insert the retaining ring into
the non-cylinder side of the cylinder hole.
4. The cable and connector must be coiled inside
retaining ring before inserting mortise into door
prep pocket (Figure 7A2). Make sure the plastic
retaining ring is seated correctly.
Installation Instructions - Door Preparation
6
NOTE: Lock body is shipped with a removable perforated
sticker covering the retaining ring on the non-cylinder side
(inside of door) of the lock body.
Cables and connectors are coiled inside the retaining ring.
• If the handing of the lock body does not need to be
changed, skip 2 and proceed to 3.
c
Prepare Lock Body
Perforated
Sticker
Slot
Plastic
Retaining Ring
Inside of Door
(non-cylinder side)
Installation Instructions - Change Hand of Lock Body
7
a
Retaining Ring
Harness must be coiled
inside Plastic Retaining Ring
Figure 7A1 Figure 7A2