Assa Abloy Sargent Passport 1000 PG, Руководство по установке

Страница: 22 / 24

22
1-800-727-5477 • www.sargentlock.com
A7807D 12/22
Passport 1000 PG
Mortise Lock
Copyright © 2012, 2022, SARGENT Manufacturing Company. All rights reserved.
Reproduction in whole or in part without the express written permission of SARGENT Manufacturing
Company is prohibited. Patent pending and/or patent www.assaabloydss.com/patents.
Operational Check
21
IMPORTANT: Be sure to test functions prior to closing door. In all cases, perform the following checks:
1. Ensure that inside lever retracts latch (and deadbolt for deadbolt functions).
• For devices with cylinders, the following checks apply:
Insert key into cylinder and rotate:
a. There should be no friction against lock case, wire harness, or any other obstructions.
If harness friction exists, refer to the section on ‘Installation of Inside Component Assembly’ in
PERSONA instructions A7807 (this manual).
b. The key should retract the latch and the key should rotate freely.
c. The key should extend and retract the latchbolt.
• For units without a keypad, the following checks apply:
Insert test card marked NO PIN and retract:
a. Ensure lockset displays a green fl ash (and no other lights).
b. Ensure outside lever retracts latch, the door opens, and that there is no binding against lock case,
wire harness or other obstructions.
• For units with a keypad, test the keypad by using the following checks:
Create and insert a test card marked ’PIN 1234’ and retract:
a. Ensure lockset displays solid yellow light.
b. Type 1, 2, 3, 4 on keypad.
c. Ensure outside lever retracts latch, the door opens, and that there is no binding against lock case,
wire harness or other obstructions.
d. Test again with card marked ’PIN 5678’.
e. Test again with card marked ’PIN 9090’.
2. Any rapid yellow or rapid red fl ashing lights indicate a low power condition. Check the battery voltage at
the top of the battery pack to check for the required 9V. If the voltage is correct, inspect the wiring for a
possible short.
3. When you have completed the tests, close the door, ensuring latchbolt and deadbolt fully extend into strike
plate without binding.