700703 REV H 09/18
ADAEZ Wireless Interface Module
Installation and Operation Instructions
14 of 17
17
Troubleshooting Recommendations - con’t
No
Symptom
Recommended Remedy
5
Lock does not unlock
when an INSIDE activation
is sent.
·
If RF buttons are used and LED D3 is NOT flashing perform
troubleshooting steps in section “RF transmitters will not
Sync to WIM”
·
If hardwired buttons are used and D3 is NOT flashing:
o
verify wires are connected to the Common (C) and
Normall Open (NO) switch contacts.
o
Use a multimeter to verify a contact closure on
INSIDE BUTTON.
·
If LED D3 is flashing
o
Verify the jumper on the FIRE PANEL is in place.
·
Measure the voltage across the LOCK POWER input and
verify the correct voltage for the lock.
6
Lock does not unlock
when an OUTSIDE
activation is sent.
·
If RF buttons are used and LED D4 is NOT flashing perform
troubleshooting steps in section “RF transmitters will not
Sync to WIM”
·
If hardwired buttons are used and D4 is NOT flashing:
o
verify wires are connected to the Common (C) and
Normall Open (NO) switch contacts.
o
Use a multimeter to verify a contact closure on
INSIDE BUTTON.
·
If LED D4 is flashing
o
Verify the ACCESS CTR IN contact is closed while
activation is being sent. The WIM will not accept an
OUTSIDE activation unless a valid access control
input is received.
o
Verify OUTSIDE BUTTON DISABLE contact is not
closed.
o
Verify the jumper on the FIRE PANEL is in place.
o
Measure the voltage across the LOCK POWER
input and verify matching voltage with lock.
7
The OUTSIDE BUTTON
disable does not prevent
the lock from unlocking
o
Verify the button is programmed/connected to the
OUTSIDE BUTTON contact.
