6
BLSS Trim
Installation Instructions
ML2000 Series
FM351 08/19
Copyright © 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
5
BLSS Trim Installation
1. Install strike using 3/4" strike mounting screws.
Note:
Strike must be oriented with narrower hole
on
lower half of strike and strike lip towards pull
side of door. (Figure 15)
2.
Cylinder functions only:
Slide cylinder(s) through spring and collar,
threading into lockbody until cylinder face
is flush with collar. (Figure 16)
Note:
Pull key slightly out of cylinder to help thread
into lockbody.
Note:
Cylinder must be oriented correctly. (Figure 17)
Correct
Incorrect
Note:
Key and cylinder must
be rotated as shown
Figure 17
3.
Cylinder functions only:
Tighten cylinder set screw. (Figure 18)
4. Fully tighten lock mounting screws.
Figure 15
Figure 16
Strike Lip
Wider Hole
Narrower Hole
Figure 18
Cylinder
Set Screw
