Issue 7-23-2007
Besam ICU/CCU - Equal or Unequal Panel
2
© Copyright 2007 Besam Entrance Solutions. May not be reprinted or reproduced without permission.
Mechanical Installation
Full Breakout Active Leaf Installation Procedure
Trackless Applications - Unequal Panel ONLY
1. Install bottom guide block in active
leaf. See Fig. 6, Pg. 21 (Sec. A-A).
2. Remove Full Breakout Tube.
3. Insure wheel brackets are all the way
up on carrier.
4. To install the active leaf, position the
door panel in the opened position with
the back of the door outside of the jamb.
5. Place the door under the cover and
over the DHD foot assembly at the
nose of the sidelite, being careful not
to damage the cover. Position the bot-
tom of the door such that the DHD foot
assembly inserts into the track inside
the bottom rail of the active leaf. Then
tilt and lift the wheel brackets on top
of the door onto the track inside the
header. See Fig. 14.
6. Install the anti-risers by sliding the
door past the anti-riser block and lin-
ing up the carrier and block. Insert
anti-riser bolt and secure. See Fig. 11,
Pg. 25.
7. Adjust the vertical adjustment screw
on the PSA arm to lift the lead edge of
the door and ball catch into alignment
with the ball catch receiver. See Fig. 12,
Pg. 25. Slide open door completely.
Note:
if the glass has not been previously
installed, you will need to recheck align-
ment once the glass is in place and read-
just as necessary.
8. Slide door completely open. Adjust the
black endcap attached to the header
such that it is 1/8" away from the
extended rail. Trim the Full Breakout
Tube to this length. Caulk both legs on
the Full Breakout Tube and reinstall.
9. Loosen wheel brackets & anti-riser
bolts and adjust door to proper height
using the adjustment screw on the
wheel brackets, taking into account the
floor conditions for the full travel of
the doors. Tighten wheel brackets.
10. Slide door to full open position, and
ensure that door breaks out.
Fig. 14
