WORK INSTRUCTION
Work Instruction No.
WI_AB_CXXXXXXXXX
5
Step 6
Inspecting the Installed Seal for Proper Installation
View the seal from the backside to ensure the seal has been pressed all the way into
the sealplate bore. There should be no gap present between the seal and the bore.
Step 7
Setup Motor for Component Installation and Remove Slinger
Setup the motor on its rear end. The motor shaft should be sticking up into the air.
Remove the rubber slinger from the motor. If a slinger is not present, collect a slinger
from the “SLINGER” box/tray for later installation. The slinger spins and kicks off any
water drops during operation, preventing it from getting into the motor.
Step 8
Install Adapter Plate
Install the adapter plate onto the motor. The 4 bolt holes should line up with the motor
mounting holes.
