WORK INSTRUCTION
Work Instruction No.
WI_AB_CXXXXXXXXX
10
Step 19
Installing the Case Assembly
Place the case onto the sealplate, over the o-ring.
Ensure the holes in the case flange, sealplate, and motor adapter are aligned by
placing an extended 3/16” allen bit through the holes. Wiggle the bit to line up all the
holes.
By hand, thread the case bolts through the 8 holes in the case flange and into the
motor adapter plate.
Leave the bottom 2 screws out if using a stainless steel baseplate. (Check the
BOM on the work order). This can be seen in the picture on the right.
If using a baseplate, inspect the baseplate to ensure the rubber cushion is installed on
the radius of the baseplate. If not, install the rubber trim.
Install the bolts on top of the baseplate, sandwiching the baseplate between the screw
and the case flange.
Tighten the screws in a crisscross pattern until tight (approximately 8 ft-lbs) using the
air ratchet and a 3/16” allen bit.
