•
Secure the axle and wheel spat assembly to the
landing gear with the Nyloc style nut.
•
With the wheel spat level, install a self tapping screw
through the pre-drilled hole in the alloy landing gear to
prevent the wheel spat from rotating
STEP 2: Landing Gear & Wheel Spat Assembly (Nose Gear)
•
Remove the upper scissor arm from the nose leg
assembly.
•
Fit the lower leg section through the wheel opening of
the wheel spat.
•
Position the nose leg fork in the pre-installed plywood
support in the wheel spat.
•
Position the axle hole so that it is approximately 16mm
(5/8”) from the bottom of the wheel spat.
•
Drill a 4mm (5/32”) hole.
•
Fit the axle through the wheel spat assembly and the
wheel using one of the 4mm nylon spacers on either
side of the wheel.
•
Take care not to over tighten the Nyloc nut which
could cause the wheel to jam.
•
Re-assemble the nose leg.
•
Install both the main landing gear and
nose gear assemblies using the 18mm
long cap screws and washers provided.
STEP 3: Install the Main Gear & Nose Gear
