Ashley KP130, Руководство пользователя

Страница: 12 / 44

-12-
6. The Room Fan will not operate at this time since the unit must reach a factory preset temperature.
Do not open the viewing door, the auto-start igniter will get very hot during this test. The stove will automatically
shut down after approximately 23 minutes.
• DO NOT USE CHEMICALS OR FLUIDS TO START THE FIRE - Never use gasoline, gasoline-type lantern fuel, kerosene,
charcoal lighter fluid, or similar liquids to start or “freshen up” a fire in this stove. Keep all such liquids well away
from the stove while it is in use.
• HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKINS
BURNS.
• DO NOT USE GRATES OR ELEVATE THE FIRE. BURN POT HAS TO BE IN ITS INTENDED LOCATION.
This heater is designed to burn only PFI Premium grade pellets. DO NOT BURN:
1. Garbage;
2. Lawn clippings or yard waste;
3. Materials containing rubber, including tires;
4. Materials containing plastic;
5. Waste petroleum products, paints or paint thinners,
or asphalt products;
6. Materials containing asbestos;
7. Construction or demolition debris;
8. Railroad ties or pressure-treated wood;
9. Manure or animal remains;
10. Salt water driftwood or other previously salt water
saturated materials;
11. Unseasoned wood; or
12. Paper products, cardboard, plywood, or
particleboard. The prohibition against burning these
materials does not prohibit the use of fire starters
made from paper, cardboard, saw dust, wax and
similar substances for the purpose of starting a fire in
an affected wood heater.
WARNING: Burning these materials may result in release of toxic fumes or render the heater ineffective and cause
smoke.
START-UP PROCEDURE
1. Verify that the hopper is clean and free of foreign matter.
2. Verify that all of the required exhaust/inlet connections have been made in accordance with this manual
and that the stove is plugged into an outlet (an outlet surge protector is highly recommended).
3. Fill the hopper with wood pellets; do not allow any part of the bag or any other foreign material into the
hopper, as this may jam the auger.
4. Ensure that all pellet matter is cleared from the hopper seating surface.
5. Close the hopper lid. The unit WILL NOT feed fuel with the hopper lid open.
6. Make sure that the viewing door is securely closed (the safety pressure switch will not allow the stove to feed
fuel if there is no draft pressure inside the stove) .
7. Press the “ON” button on the control pad and set the “heat Setting” to your desired setting.
8. The stove will begin to feed fuel and the auto-start igniter will ignite the fuel in approximately 5 minutes.
Once a consistent flame has been established, you can adjust the “Heat Range” and “Blower Speed” on the
control pad to your desired settings. (Note: The distribution blower will not function until the heat exchanger in the
stove reaches the factory preset temperature).
Attempts to achieve heat output rates that exceed heater design specifications can result in permanent damage
to the heater.
FIRST FIRE
Adjust the “Heat Range” and “Blower Speed” to a “3” setting and allow the stove to operate in this manner for
approximately three (3) hours (or more if necessary), allowing the stove to “cure out” as the paint and oils from
the manufacturing process burn off. We recommend that you open doors and windows in your home during this
process. Adjust setting to desired setting.
WARNING: Never shut down this unit by unplugging it from the power source.
SHUT DOWN PROCEDURE
Press the “OFF” button on the control pad to put the stove in shut down mode. At this time, the red light above
the pad will illuminate. Once this is done, the auger will stop feeding pellets, but the distribution blower and