Locate the 4 pins on the
handles into the 4 holes
in the cogs. Then give the
handles a sharp hit with
your fist so they snap
down tight onto the cogs.
Place the castle inside the frame and attach with 40mm (1½") hex head bolts, washers and nylon knobs.
Tap the heads of the bolts into the counter bored hole in the inside of the castle side and tighten the knobs
Place a washer onto the nylon knobs with the thread rod, thread them
through the slot in the loom side and into the nuts inserted into the
rear of the castle sides.
until the heads of the bolts are level or below the surface
of the castle side. Otherwise the end of the heddle
frames will catch on them.
