Attach beater frame to the
support rails. Leave 0.5mm
(1/32") gap so the beater
can swing freely.
Note: If the beater frame
rubs against the loom
sides loosen the wing
nuts and retighten.
Stretchy cord - knot the
cord at one end, slide
through the hole in the
beater support rail, the
hole in the castle front
and knot the other end.
To fold the castle, loosen the front knobs slightly and completely remove the back
knobs. Lift and slide the castle down the slots. When it reaches the safety stop,
lift the bottom of the castle again and
allow it to fold down completely. Then
insert the knobs back through the
slot and into holes near the top of the
castle side and tighten. This will ensure
the castle is well supported when
transporting the loom.
