10. Assembly
10.1.
Ultraviolet Germicidal Lamp installation:
Grasping lamp gently by end caps, align pins with lamp holder socket and insert pins into socket.
Rotate the clockwise or anticlockwise until the bulb locks into place. DO NOT twist the bulb or
put excessive force on the glass or end caps as this may cause the bulb to break; see illustration
1 below.
10.2.
HEPA/Carbon filter installation:
Begin by resting bottom edge of filter inside of unit and then gently push the filter into the housing
until it fully seats; see illustration 2 below.
10.3. Prefilter
installation:
Place the prefilter into the housing against the HEPA/Carbon filter. Turn the swivel locking tabs
to secure in place; see illustration 3 below
10.4.
Front cover installation:
Place the bottom tabs of the front cover into the slots on the bottom of the housing. Push the
cover inwards and using your thumbs press inwards on the upper outer corners of the cover until
you feel it “pop” into place. Release pressure and cover should be locked in place; see illustration
4 below. If unit does not chime when connect to a power source check to make sure front cover
is fully secured in place.
1 2 3 4
11. Troubleshooting
Problems Cause
Solution
The unit does not turn
on.
1.Not properly plugged in
2.Front cover not secure
3.Remote control batteries dead
1.Plug into electrical outlet
2.Secure front cover
3.Replace batteries
No air comes out
Air inlets or outlet blocked
Remove any objects
blocking air inlets or outlet.
110112
