POOL TECHNOLOGY
First start
The first start of the PP60 pH should be in the fresh water without any additional chemicals. Turn on the
PP60 pH by plugging it into a power socket.
You can move in the settings by the key MODE, the values displayed for particular items can be set by the
keys + and -. Press OK to confirm. Return to default screen by press MODE several times.
Don't forget to enter
2. Pool volume
in m
3
.
1. By pressing the
4. Manual dose
you can test the tubes for leaks. During the manual test pH-liquid
should moving through the tubes. When test is over liquid should not fall back to canister.
2. Select the
1. Required values
and setup the required pH-value and press OK
3. Select what type of pH you want
5. pH+ / pH-
.
4. After the start of the filtration pump check if water flows to the probe.
5. Now is the time for the probe calibration. Measure teh pH-value of the pool water by the manual
tester. In case the value measured by the regulator differs from that one found by the manual
measurement, make the correction in the item
3. Calibration
and confirm by OK. To the operation
mode you return by the repeated pressing MODE.
Tel.: +420 244 912 210
Email: [email protected]
Stránka z
4
6
