TD 91684GB
16 April 2015 / Ver. G
Installation Guide
T942C and T942C/2 Central Unit
11
2
Run the wiring out through the partition.
1 2 3 4 5 6
1
2
1
Slots
Figure 10. Wiring of modular or twisted pair cabling, 1 and 2.
3
Use the slots at the opening to secure the wiring with cable straps.
1.4.5
Addressing
Assign the T942C an address on the C-bus by setting address switch SW01 hexadecimally.
See the
System Installation
document, chapter Addressing.
SW01
OFF ON
1
8
Figure 11. Addressing on T942C
•
If no additional units are connected to the C-bus: Assign the Central Unit address 00.
•
If additional units are connected to the C-bus, the address must not be the same as any
other unit on the C-bus. Note that units on the C-bus must always be assigned addresses
in ascending order starting with 00.
