ELECTRIC WIRE LIFT
9
PREPARATION
◆ Use the lift with opening legs full.
Set the legs correctly. Otherwise falling down may occur.
◆ Use the lift with grounding 4 legs.
Otherwise falling down may occur.
Aluminum Cylinder
Mast
holding belt
Ground
Slide Leg
Slide Button
Slide Ring
Leg Fix Screw
Leg
CAUTIONS
Assembling
③ Loosen the leg fix screw of the slide ring and open the legs.
④ Once fully opened legs, tighten the leg fix screw.
⑤ Push the slide buttons and make the legs longer.
Make each leg longer until each all of 4 legs are grounded.
The length of slide legs should be shorter than upper second
red mark from leg edge.
⑥ The slide leg is fixed once remove your hand from the slide
button.
① Set the lift on a flat and solid ground.
In case the setting position is not stable, cover the
position where the aluminum cylinder is grounded.
② Remove the mast holding belt from the mast.