BEAVER 10
20
Trouble
Possible Cause
Solution
Vibration
while
sawing.
Tension handle not set in tightning
direction.
Set the tension handle in the tightening position.
Installation of Back-Plate is bad.
Move mounting position of Back-Plate Stopper.
Adjustment of blade guide F.
If blade guide F is really close to a workpiece, it may
cause vibration. So, separate blade guide F and
workpiece 20-30mm.
Wobble of the body.
If fixed aspect is not flat and the body have wobble,
these things may cause vibration.
In this case, before using this machine, pitch Height
Adjuster and make the body no wobble.
Saw blade
coming off
T.P.I. not matching workpiece.
Select the saw blade having T.P.I. which
matches the workpiece.
Saw blade setting fault.
Re-set the saw blade until it makes contact with the back
stopper
Saw blade or Pulley rubber or Workpiece or
Blade guide and bearing stained with oil.
Wipe oil off the Saw blade or Pulley rubber or Workpiece
or Blade guide and bearing and re-set it.
The movement of Following Pulley is poor.
Remove foreign matter to run the following pulley
smoothly.
Tension handle tightening fault.
Set the tension handle in position.
Pulley rubber worn.
Replace the pulley rubber.
Saw blade
sinking
Saw blade lower than workpiece at end of
cutting
Adjust the stop bolt to raise the saw blade position.
Motor will
not run
Overload protecter activated.
Press the overload protecter re-set button.
Voltage dropped or long extension cord
used.
Various machines connected to the same
receptacle.
Use an extension cord of large capacity.
(Refer to page 10.)
Workpiece
cannot be
clamped
Clamp bolt worn.
Replace the Clamp bolt.
