Arturia beatstep pro, Руководство пользователя

Страница: 40 / 93

40 ARTURIA – BeatStep Pro – USER’S MANUAL
6 PROJECTS
There are many independent features for each sequencer. But a Project is where you will
find parameters that affect all three sequencers at the same time.
The internal memory of the BeatStep Pro holds a total of 16 Projects. You could think of
a Project as a single song (although it could be an entire performance). Each one
contains:
•
16 patterns for each of the three sequencers (SEQ1, SEQ2 and DRUM), including
all of the Swing, Random and Probability settings for each pattern
•
A Control Mode preset, with independent settings for each BeatStep Pro control
•
The status of the TRANS LNK and PRST LNK buttons.
See section 12.8.5 for information about Project parameters that are only available
through the MIDI Control Center software.
6.1 Loading a Project
To load a Project, hold the PROJECT button and press the Step button that corresponds
to the number of the Project you want to load. Be sure you have saved your current
Project somewhere before you do this!
Projects can also be loading during performance while the sequences are running.
Note: There’s a preference in the MIDI Control Center where you can specify whether
the new Project should be loaded instantly or wait until after the Drum sequencer
reaches the end of its current pattern. See
section 12.8.5.6 to learn about this feature.
6.2 Project management
6.2.1 Saving a Project
Caution: When you follow these instructions you will overwrite the selected Project and
all of its patterns. Be sure this is what you want to do! If not, be sure to find out which
memory location is available and store the Project there instead.
Once you have chosen a Project location,
•
Hold the SAVE button
•
Press the PROJECT button and hold it
•
Press the desired Step button number.
To recall this Project later follow the steps described in section 6.1 .