Artesyn Embedded Technology ATCA-7490, Инструкция по установке и эксплуатации

Страница: 129 / 372

Maps and Registers
ATCA-7490 Installation and Use (6806800U11F)
129
5.1.4.2.9 Modem Status Register (MSR)
This 8-bit register provides the current state of the control lines from the modem or data set (or
a peripheral device emulating a modem) to the processor. In addition to this current state
information, four bits of the Modem Status Register provide change information. Bits 03:00 are
set to a logic 1 when a control input from the Modem changes state. They are reset to a logic 0
when the processor reads the Modem Status Register.
6 Transmitter Empty (TEMT) indicator
TEMT bit is set when the THR and the TSR are both empty. When
either the THR or the TSR contains a data character, TEMT is
cleared. In the FIFO mode, TEMT is set when the transmitter FIFO
and shift register are both empty:
1: THR/Transmit FIFO/TSR empty
0: THR/Transmit FIFO/TSR contains data 1 LPC: r
7 FIFO data error
In the FIFO mode, LSR7 is set when there is at least one parity,
framing, or break error in the FIFO. It is cleared when the
microprocessor reads the LSR and there are no subsequent errors
in the FIFO. If FIFO is not used, bit always reads 0:
1: FIFO data error encountered
0: No FIFO error encountered 0 LPC: r
Table 5-33 Line Status Register (LSR) (continued)
LPC IO Address: Base + 5
Bit Description Default Access