Artesian Spas platinum series, Руководство пользователя

Страница: 28 / 44

MAINTAINING YOUR SPA cont...
REMOVING, INSTALLING AND CLEANING FILTERS
These are the steps needed to successfully replace your filters.
You should replace your disposable spa filters and clean your
nondisposable filters every four months.
1) Turn off all power to your spa and remove
the filter lid by lifting it out towards you.
2) Turn the filter counterclockwise and
remove it from the filter well.
3) Dispose of the used filter.
5) To replace, set screen back into its place
and turn clockwise to fasten. DO NOT
over-tighten.
6) Place the new filter into position and turn
clockwise to fasten. DO NOT over-tighten.
7) Follow the directions 1) and 2) for the
pleated filter cartridge. You then rinse the
filter with a garden hose and soak the filter
in a mixture of one pint of filter cleaner
with 2.5 gallons of water for at least
12 hours. The filter must be completely
submerged. You then follow the directions
5) and 6) to replace the filter
WARNING: Power to your spa must be turned off prior to
removing your filters. The suction at the filter is extremely strong
and can cause injury if there is no filter. NEVER run your spa
without the filters properly installed. Injury to person and damage
to the equipment can occur. Any damage to equipment due to this
circumstance will not be covered under warranty.
WINTERIZING YOUR SPA
It is not recommended that you drain your spa completely during
freezing conditions. We recommend that you leave your spa full of
water with the power on to keep the tub from freezing. If you decide to
drain your spa during freezing conditions, contact your dealer for help.
Contact your Artesian dealer before refilling a drained spa in freezing
temperature.
WARNING: Damage to your spa caused by freezing is NOT
covered under warranty. Please contact your local Artesian
dealer to assist you in winterizing your spa.
REPLACING THE LIGHT BULB
1) Turn off the power at the main electrical service panel.
2) Remove front access panel.
3) Locate and remove the reflector by turning it counterclockwise until
free from wall fitting.
4) Remove the bulb from the holder.
5) Replace with new bulb. Your Artesian dealer has these bulbs in
stock.
6) Replace the reflector by screwing it clockwise back onto the wall
fitting.
7) Replace the front panel.
8) Turn power on at the main electrical service panel.
NOTE: The spa light bulb is not covered under warranty.
51 50