Artemis Vision RaPTr (Rapid Pallet Tracker) | System Set-Up Guide
11
Parameters Descriptions:
Minimum Module Count Vertical
- Minimum number of modules in each column of
the data matrix.
Maximum Module Count Vertical
- Maximum number of modules in each column of
the data matrix.
Minimum Module Count Horizontal
– Minimum number of modules in each row
of the data matrix.
Maximum Module Count Horizontal
– Maximum number of modules in each row
of the data matrix.
Barcode Results Per Image
– Quantity of barcodes expected to be detected in each
image.
Scanner Location ID
– Unique identifier for dock door or barcode reader location.
Server IP and Port
– Reference “Scanner Interfaces and Architecture” document.
Back Off Truck Time
,
Photo Eye Debounce Time
, and
Barcode Scan and Pallet
Detection Delay
– Reference I/O Detection Appendix, if applicable.
Server Response Dwell Duration
– This is the time the server’s response message
stays on screen at the Scanner Unit. Default is 5 seconds.
Block Barcode Window
– Determines the amount of time the system will wait
before reading the same barcode again. Default is 30 seconds. If this is set to be too
short a duration, the system may read the same barcode more than once, especially
if the fork truck operator allows pallets to sit in front of the camera. For testing
purposes this can be set to lower values, but 30 seconds is normally long enough for
the barcode to be read, and the pallet to be loaded on the truck before being ready
to scan another barcode.
Low Diskspace Threshold
– Determines the amount of remaining space can be on
the system hard drive before the system begins to delete image files. The system
will remove the oldest files first once this threshold has been surpassed.
Delete Images Timespan
– Automatically deletes image files after this amount of
time has passed.
Image Saving Resize Factor
– Allows one to set the compression applied to saved
images. Default setting is 8 (8X smaller than raw images from camera).
Keyboard Wedge IP
– Applicable if using the Keyboard Wedge Option (see
Keyboard Wedge Addendum, if this Option was purchased).
Barcode RegEx Filter
- This field allows one to insert a Regular Expression as a
means to filter barcodes to be read. For instance one could have a leading value (i.e.
001-) at the start of all pallet ID barcodes to ensure that only those barcodes are
read by the system.