Artel DigiLink DLC910, Инструкция по установке и эксплуатации

Страница: 18 / 28

8 DLC910 Function Module Installation and Operations Manual
DLC910 Function Module
2. From the Home page menu bar, click
Shelf View
.
The Shelf View page displays, which shows the rear chassis panel along with the Installed Modules table.
3. From the Installed Modules table, click the
DLC910
link listed in the Module Type column.
The Module Status page displays, which shows the module’s current configuration, alarm conditions (if
any), and SFP status.
4. From the menu bar, click
Configuration
.
The Configuration page displays.
5. Configure the module operations as follows:
• From the Input Settings panel, configure the following items for each display quadrant:
–
Video Source
—Enable or disable a video source. From the drop-down list of available source
inputs, select the input source to enable or select
Disabled
. The sources that display in the
drop-down list depends on the function modules installed in the host chassis. Input source ports
are as follows:
• BNC Input (1)
• Available backplane inputs
• SFP Inputs (2)—Optical or HD-BNC
Note:
You cannot use HDMI SFPs as an input source because the output signal,
which is always routed to all SFPs, is internally looped backed by the SFP
as an input inside HDMI SFPs. This causes an infinite recursion in of output
signal being fed back as an input.
–
OSD (On Screen Display) Text
—Enter the text string to display along with the source input. You
can enter a maximum of 16 ASCII characters.
–
Video Alarm
—Enable or disable the video alarm for the quadrant. If the video source is disabled,
no alarm occurs.
• From the On Screen Display Settings panel, configure the following items:
–
OSD Text
—Enable or disable the display of the OSD text in both Quad Mode and Fullscreen
Mode.
–
Audio Channel Levels
—Enable or disable the display of audio level meters and status indications
across all quadrants in both Quad Mode and Fullscreen Mode. A single green segment displays at
the beginning of any active audio channel meter if the channel is detected in the input stream,
even if the audio level is zero.
–
Input Signal Formats
—Globally enable or disable the display of the current video input format
detected (if any) in both Quad Mode and Fullscreen Mode. If the format is not supported, “Invalid
Format” displays. No Input displays if the input is disabled.