Artel DigiLink DLC910, Инструкция по установке и эксплуатации

Страница: 16 / 28

6 DLC910 Function Module Installation and Operations Manual
DLC910 Function Module
Installing the DLC910 Module
The DLC910 module and associated SFPs are hot swappable, enabling you to safely install them while power is
applied to the host chassis. Before you install the module, see the DLC910 data sheet for a detailed description
of the module specifications, including environmental requirements, that you must adhere to when installing
the module.
Note:
You must install the DLC910 module in a chassis that includes DL Manager functionality as the
module requires DL Manager for configuration and monitoring purposes. For more information,
see the “Configuring the Module with DigiLink Manager” section on page 7 .
To install the DLC910 module in the host chassis (see Figure 4) , perform the following steps:
1. From the back of the chassis, remove the two screws that secure the blank tray to the unused function
module slot.
Use any available function module slot.
2. Slide the module into the chassis slot using the printed circuit board guide rails on either side of the slot.
3. Push the module in until it is firmly seated into the backplane and flush with the chassis.
4. Tighten the two mounting screws that secure the module to the chassis.
5. Install an Artel approved SFP in sockets A and B of the module.
Push the SFP into the socket until it is firmly seated in the socket.
6. Insert a blank tray in any unused chassis module slot to maintain proper ventilation.
Caution
To maintain proper operating temperature all chassis slots must be filled. Use a blanking tray in any
unused chassis slot. Failure to fill all slots may result in over heating of some modules.
Figure 4. DLC910 Module and SFP Installation
Mounting Screws (2)
SFPs