User Guide -
MeshAP 3100 5GHz/2.4GHz Full Duplex Mesh Network Access Point
DOC-6200-0152
- 63 -
Chapter 12
Point-To-Point MeshAP Locator
Using Point-To-Point Station Locator to adjust directional antenna
Point-To-Point Station Locator is to discover the RF signal of the receiving MeshAP’s
directional antenna. And also fine-tune the directional antennas to maximum RF signal
strength between the point-to-point units.
IMPORTANT:
The Mesh AP will not form a mesh links to other Mesh AP, while the
Point-to-Point Station Locater is in operation.
The channel number selected must be the same as the channel that other Mesh AP
is operating on.
To Setup up Point-To-Point Directional Antenna
Step 1. Login
to the
MeshAP
unit
Step 2. Go to
Site Survey
under
MESH
section
Step 3.
Click on the
Point-To-Point Station
Locator
tab
Step 4.
Set the Channel number of the receiving
unit trying to locate.
Step 5.
Move the Directional Antenna until the bar
at the SNR(dB) reaches the highest level.
Note:
To form a Good Mesh Link, SNR need to
be at least 24dB.
SNR Color Bar Information
