●
●
●
●
●
9044 Floor Angle (1)
●
●
●
●
●
9046 Front Floor Frame (1)
●
●
●
●
●
9047 Rear Floor Frame (1)
●
●
●
●
●
8947 Side Floor Frame (2)
The front floor frame is made up of
two pieces. The holes in these pieces
will align when the pieces are posi-
tioned with correct amount of over-
lap. Proceed as follows:
1
Position floor angle inside chan-
nel of front floor frame in the direc-
tion shown and fasten with five 1/4"
bolts from the bottom with nuts on top.
Place the floor frame pieces on the
foundation. Assemble the four cor-
ners of the floor frame using two
screws at each corner as shown. At
the front corners fasten 3/8" bolts
through from the bottom with nuts on
top.
2
Measure the floor frame diagonally.
When the diagonal measurements
are equal, the floor frame is square.
NOTE
Do not fasten the floor frames to
your foundation at this time. You
will anchor the building after it is
erected.
If Arrow Foundation is being
used, disregard note above and
follow Foundation Kit instructions.
The floor frame
must be square
and level or holes will not align.
15
Step 2
E15
●
Parts Needed For
●
Floor Frame Assembly
Level
RIGHT
FRONT
9047
8947
9046
8947
LEFT
REAR
3/8" BOLT
STEP
2
STEP
1
1/4" BOLT
8947
FRONT
8947
9044
9047
9046
When Diagonal Measurements
are Equal the Floor Frame
is Square
END VIEW
5/16" SCREW
