![Arris BGW210-700 Скачать руководство пользователя страница 14](http://html.mh-extra.com/html/arris/bgw210-700/bgw210-700_install-and-operation-instructions_2976084014.webp)
Chapter 3: Hardware Gateway Installation
365-095-30882 Revision 4.0
BGW210-700 Broadband Gateway Release 1.0 Install and Operations Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved.
14
Alternatively, you can connect the BGW210-700 Broadband Gateway to the Internet using the
WAN Ethernet port (labeled ONT):
1.
Connect one end of an Ethernet cable to the WAN Ethernet port on the BGW210-700
Broadband Gateway.
2.
Connect the other end of the cable to the operator provided WAN Ethernet jack or ONT.
After the BGW210-700 Broadband Gateway recognizes the connection, the Broadband light
blinks green for a moment and then turns steady green. See
Status Indicator Lights
(page 17)
under Basic Troubleshooting for all Broadband light indications.
Connecting VoIP Telephones
The BGW210-700 Broadband Gateway includes one RJ-14 port (labeled Phone 1 & 2) with the
capacity to support two phone lines using a splitter or multi-jack adapter.
Note: The BGW210-700 Broadband Gateway supports two VoIP lines over
one RJ14 (FXS) VoIP port. To connect two phone lines, an inner and outer
pair splitter adapter must be attached to the RJ14 (FXS) VoIP port to
terminate both lines.
Warning: Do not connect the VoIP lines to your current home telephone wiring, especially if
your home has an alarm system. Ensure that you are subscribed to VoIP service for this
interface to be used.
As shown in the figures below, to connect phones directly to your gateway:
1.
Connect one end of the phone cable to the gray Phone Lines 1&2 connector on the
BGW210-700 Broadband Gateway.
2.
To connect to the telephone(s), do one of the following:
For one phone, connect the phone cable directly to the telephone.