ARRI Orbiter, Инструкция по безопасности и установке, Страница: 19 / 25

19
Power SourcePower Source
19
When using a battery pack, follow all safety instructions of the manufacturer. Only use battery packs that
meet all the specifications listed. Use of unsuitable battery packs can damage both the fixture and the bat-
tery pack.
To Insert and Remove the 3 pin XLR connector
• The main switch of the battery pack, if present, must be turned off.
• Insert the XLR connector into the battery pack connector (20) without force. Note the position of the lock-
ing device!
• The connector must snap into place. Repair or replace the connector if it does not click into place.
• If possible, switch off the battery pack before removing the connector. Press the latch on the connector
and pull it out of the connector.
Tips for using battery packs
It is not possible to give a reliable indication of the operating time with a battery pack. The actual operating
time depends strongly on age, state of charge, type of battery pack and brightness setting of the Orbiter.
If the battery pack does not have a switch for switching on and off, the brightness of the orbiter should be
set to zero before disconnecting the connector cable to the battery pack. This will reduce the load on the
connectors and increase the lifetime of the connectors.
The pin out of the battery pack must correspond to the pin out shown above. Connectors with dif-
ferent pin out may cause damage to the Orbiter and the battery pack.
The Orbiter switches off below the minimum voltage of 48 V
៑
. Battery input voltages above
53.5 V
៑
will damage the fixture.
If the Orbiter switches off due to under voltage, you must disconnect the battery pack from the
Orbiter before connecting the fixture to an AC power source.
NOTICE