ARRI Orbiter, Инструкция по безопасности и установке, Страница: 13 / 25

13
Physical InstallationPhysical Installation
13
To Mount the Yoke
Both yoke versions feature the quick release system for mounting and removing the yoke without a tool.
• Place the Orbiter on a smooth, stable surface or mount the stirrup on a tripod.
• Align the yoke adapters of the yoke (4, short side down).
• Position the yoke adapters under the two yoke brackets of the Orbiter.
• Slide both yoke adapters into the yoke brackets on the fixture until both latches engage. When pushed in,
the levers fold out and back again. The yoke is locked properly, when both levers are fully retracted and
the red markings are not visible.
To Remove the Yoke
Both yoke versions feature the quick release system for mounting and removing the yoke without a tool.
• Flip out one lever and press the stirrup slightly downwards until the yoke adapter slides out of the yoke
bracket
• Repeat the procedure for the other side and remove the yoke from the fixture.
Heavy weight! Risk of injury and damage.
When installing the Orbiter and accessories, observe all safety instructions, especially that:
• the yoke brackets do not open unintentionally,
• the tilt locks do not release unintentionally,
• the quick lighting mount is locked,
• the antenna is securely attached,
• the yoke is mounted hanging or standing vertically.,
• Tripods are set up in a stable position. Tripods need to be approved for the load they need
to carry,
• each Tripod is stabilized with sand bags, and
• the Orbiter is secured against tipping over when set up on the ground.
Note the weight of cables and accessories!
WARNING!