ARRI Orbiter, Инструкция по безопасности и установке, Страница: 16 / 25

Basic Features
16
To Remove and to Insert the Control Panel
The control panel may be removed and inserted with the fixture powered. The last setting of the fixture is
retained when the control panel is removed.
To remove the control panel:
• Push the control panel slightly to the left.
• Lift the control panel out of the recess on the right.
• Pull the control panel to the right out of the recess.
To insert the control panel:
• Push the control panel diagonally to the left into the recess.
• Press the right side of the control panel into the recess and push it to the right until it locks in place. The
control panel is magnetically fixed in the recess. When the fixture is powered, the control panel is ready
for operation after a short time.
To Connect and Disconnect the Control Panel Cable
• Plug the 4-pin Lemo connector of the connector cable into the connector of the fixture and the control
panel. The connector locks automatically.
• Pull back the ring of the Lemo connector to unlock the connector and pull out the connector.
To Power and use the Orbiter
The Orbiter has no mains switch. After connecting the fixture with the power source or switching it on with
the mains cable inline mains switch the Orbiter initializes for a few seconds and is ready for operation. The
Orbiter will operate with the settings made on the fixture menu or received by DMX / RDM, Art-Net or sACN.
Please observe the information in the following section.
Strong Neodymium Magnet - Danger of Injury!
Neodymium magnets are extremely powerful. The very strong force between the magnets
can cause serious injuries. Fingers and other parts of the body can be trapped between
two magnets. Strong magnets can affect the operation of pacemakers or other implanted
medical devices.
WARNING!
Drop Out of Control Panel - Danger of Injury!
Always check that the control unit is mounted securely in the fixture. Danger of injury
through falling control panel.
WARNING!
The control panel can be used directly at the Orbiter or via a connecting cable remote from the
Orbiter. If two controllers are used, the controller on the connecting cable has priority.
NOTICE
Intense light! Danger of eye injury.
Do not stare at the operating light source.
WARNING!