ARRI ARRIFLEX 16S, Руководство по эксплуатации

Страница: 22 / 22

By observing the following "DON'Ts” you will protect the continued safe and
reliable operation of your Arriflex:
DON'T run camera without film at high speeds.
DON'T attempt to disassemble any part of the camera. This should be
done by factory-trained personnel only.
DON'T touch mirror shutter with fingers. Clean it only with soft camel hair
brush. In any case, a spot on the mirror does not affect the picture.
DON'T exchange covers of different camera (serial numbers are engraved
on each coyer and camera).
DON'T use old or shrunk film; the registration pin's stroke is adjusted to the
perforation pitch of fresh film (0.2994) according to ASA specifications.
DON'T allow cameras to be serviced by unqualified service shops. Arriflex
cameras require special knowledge and experience.
DON'T neglect to have your camera serviced after approximately every
200,000 ft., or every two years, whichever comes first. Service should be
more frequent under adverse conditions.
Our Service Department welcomes your inquiries and is anxious to help
you with any problem or unforeseen requirements you might have.