7
Remove the two socket head fixing screws securing the head end
mattress platform section to the head end panel section.
Pull the two sections apart, taking care not to trap or pinch the actuator
cables, and lay both sections on the floor.
Coil up all the actuator cables neatly and secure them with suitable
plastic ties.
Coil the power cord around the slot in the head end mattress platform
section.
8
Put the head end panel section (A)
on its side.
Position the foot end panel (B)
section, also on its side, so that
both fixing arms overlap as shown
in the diagram.
Place the transit brackets (C) down
over the fixing arms. Both transit
brackets must be positioned with
their open sides pointing towards
the floor.
Line up the holes in each transit
bracket with the holes in the end
panel section fixing arms.
9
Use four M8 socket head screws to secure both end panel sections onto
the transit brackets.
Fasten the screws finger tight at first, then tighten them fully using a
5mm hex (Allen) key once all four screws are in place.
A
C
B
C
746-574-AM-1
49
