Arjohuntleigh Maxi Sky 600, Техническое руководство, Страница: 14 / 48

14
Service Procedures
001
.1
415
5.3
3
re
v.
8
FOR LIFTS EQUIPPED WITH LIMIT PLATE (200.14070)
4) Unscrew the two locknuts holding the limit switch
plate (A) using an 8 mm socket tool and an 8 mm
(5/16) wrench (see Fig. 25).
5) Unscrew the two nuts of the limit switch (B) using a
3/16 in or 5-mm socket (see Fig. 25).
6) Install the new limit switch in the same position as the
original. Ensure that the limit switch wires pass
through the round opening in the frame.
7) Replace the limit plate between the frame and the
strap and tighten the two bolts. Test the system by
pushing the double thickness of the strap between
the strap roller and the plate. If the installation is
correct, you should hear the switch clicking.
8) Reconnect the two blue wires of the limit switch to the main connector.
9) Perform service procedure #9 to reassemble the unit.
FOR LIFTS EQUIPPED WITH THE HIGH LIMIT SWITCH KIT (700-14075)
4) Loosen the high limit switch kit assembly by removing the 2 socket head cap screws with the 4 mm Allen key (see
Fig. 26).
5) Slide out the high limit kit assembly kit.
6) Unscrew the 2 T-20 Torx screws (see Fig. 26).
7) Route the new strap between the two halves of the high switch limit kit.
8) Join the kit’s two halves together again using the T-20 Torx screws.
9) Lower the high limit switch kit into place and reinstall the socket head screws (see ).
10) Test the system by pushing the double thickness of the strap. If the installation is correct, you should hear the switch
clicking.
11) Reconnect the two blue wires of the limit switch to the main connector, making sure they pass through the
rectangular opening in the chassis.
12) Perform service procedure #9 to reassemble the unit.
Fig. 26
Fig. 27
Fig. 25
A
B
T-20 Torx
Strap
cap screws
screws
High limit
switch kit
Socket head
High limit
switch kit
Socket
head cap
screws
High
limit
switch
wires