24
001
-005
53
-E
N
r
e
v. 5
Service Procedure 9 - Replacing the Legs
1)
Lock the rear casters to make sure the lift stays stable during maintenance.
2)
Remove the base cover and unscrew the tie rod end from the leg to be replaced and remove
from bracket (see Fig. 16). Dispose of the nylon nut.
3)
Unscrew the leg pivot bolt that holds the leg to the base assembly and remove leg (see Fig. 18).
Dispose of the stover nut.
Fig. 18
4)
Put the new leg in place and fasten the leg pivot bolt and stover nut.
5)
Reinstall the tie rod end using a new nylon nut.
6)
Put the base cover in place.
7)
Leg opening must be verified /adjusted after installation.
8)
Fully open and close the legs.
9)
Perform a safe working load test as per service procedure 22.
Warning: If one or both legs are disassembled, it is essential that all components are reinstalled
correctly. If not, the consequence may be later disengagement, which can lead to death or
serious injury.
Leg pivot bolt
