Arjo Classic Line 2, Инструкция по эксплуатации

Страница: 38 / 64

38 CLEANING AND DISINFECTION
Figure 58
Figure 59
Figure 60
Clean and disinfect with a spray bottle
(29 steps)
Remove visual residue (step 1 to 6 of 29)
1. Raise the Classic Line 2 bathtub to a convenient
working position.
2. Make sure all functions are turned off.
3. Open the Drainage plug to drain any remaining
water.
4. Detach and place the footrest at the bottom of
Classic Line 2 bathtub.
5. Shower and rinse Classic Line 2 bathtub with
water to remove visible residue. Start from the top
and move downwards.
6. Shower and rinse the footrest at the bottom of
Classic Line 2 bathtub with water to remove
visible residue. Turn the footrest and rinse again.
See Figure 58.
Clean (step 7 to 17 of 29)
7. Put on protective gloves, protective glasses
and protective appron .
8. 6SUD\GLVLQIHFWDQWÀXLGLQWRWKHGUDLQ8VHDORQJ
handled brush to scrub the drain.
9. Close the Drainage plug.
10. 6SUD\GLVLQIHFWDQWÀXLGRQDOOLQWHUQDO&ODVVLF
Line 2 bathtub surfaces, and the footrest at the
bottom of Classic Line 2 bathtub. Turn over the
footrest and spray on the other side. Pay attention
to parts, knobs and sensors attached to the bath
surface such as drain control knob and grab
handles. See Figure 59.
11. 6SUD\GLVLQIHFWDQWÀXLGLQWRWKHVXUIDFHRYHUÀRZ
See Figure 60.