Aritech 900 Series, Руководство по установке

Страница: 7 / 44

900 Series V5.1: Installation Guide, February 2000 5
To remove the pips:
-
It is important to remove only the pips that produce the desired address, as
removed pips cannot be refitted.
1. Lay the card flat on a table, pips down.
2. Insert a screwdriver into the slot of a to-be-removed pip.
3. Twist firmly.
When a card is coded, slide it into the slot on the side of the mounting base. Ensure that
it locks into position.
As the fire monitor is rotated to fit into the mounting base, the remaining pips activate the
address buttons on the fire monitor and the fire monitor’s electronic circuits read the
address.
Pre-printed and pre-punched Universal Address cards are available in sets that save time
and increase accuracy during commissioning.
Figure 1: Address setting for 950/970/990 Series fire monitors
3. S
TANDARD PRODUCTS
3.1. Installing bases and manual call points
3.1.1. Mounting bases
3.1.1.1. Bases for the 950/990 Series fire monitors - DB950
The standard mounting base is a zero insertion force base with dual finger receptacles of
stainless steel into which the detector terminals slide. You can connect cables up to
2.5 mm diameter using captive cable clamps.
There are four double terminals and one single terminal:
Address = 88
Removed pips Xpert card Base