/
7
USER’S MANUAL
Anti-freeze protection
Should the appliance be installed where pipes are
subjected to freezing, it is recommended to empty it.
Proceed as indicated below:
-
Press the ON/OFF button to switch off the appliance.
- Remove the batteries
- Close the cold water inlet isolation valve
- Open the DHW taps until both the appliance and pipes
are completely emptied.
To fill the appliance again, open the cold water inlet
isolation valve together with DHW taps until water flows
steadily from all taps.
Change of gas type
Our instantaneous water heaters are designed to function
either with Natural Gas (methane) or L.P.G. gas. If you
need to change from one gas to the other, one of our
Authorised Service Centres must be contacted to convert
the appliance.
Maintenance
Schedule an annual maintenance check-up for the
appliance with a competent person.
Correct maintenance always results in savings in the cost
of running the system.
Shut-Off due to defective flue gas discharge
This device causes the appliance to shut down in the event of an
anomaly in the flue gas discharge.
The appliance shutdown is temporary.
When normal conditions have been restored, the appliance
operates as normal. If not, the boiler shuts down and the cycle
is repeated.
WARNING!
IN THE EVENT OF A MALFUNCTION OR IF
REPEATED INTERVENTION IS REQUIRED,
SWITCH OFF THE APPLIANCE, REMOVE
THE BATTERIES AND SHUT OFF THE GAS
VALVE.
CONTACT THE TECHNICAL ASSISTANCE
SERVICE OR A QUALIFIED TECHNICIAN
IN ORDER TO REPAIR THE FLUE GAS
DISCHARGE FAULT ONCE THE CAUSE OF
THE MALFUNCTION IS DETECTED.
IN CASE OF MAINTENANCE ON THE
DEVICE USE ONLY GENUINE SPARE PARTS
FOLLOWING THE INSTRUCTIONS.
THIS DEVICE MUST NEVER BE OUT
OF SERVICE BECAUSE IT WOULD BE
AFFECTED USER’S SAFETY.
