/
5
USER’S MANUAL
1
2
3
WARNING
Installation, first ignition and maintenance work
must be performed by qualified personnel only, in
accordance with the instructions provided.
Incorrect installation may harm individuals, animals or
property; the manufacturer will not be held responsible
for any damage caused as a result.
If the appliance is installed inside the apartment,
make sure that all provisions relating to the air
inlet and room ventilation (in compliance with
current legislation) are respected.
Control pannel
1
- Knob for gas regulation
2
- Red L.E.D. - battery power level
3
-
D.H.W flow/temperature knob
Battery insertion
- unhook the battery compartment cover placed on
the bottom of the appliance
- Insert 2 batteries (1,5V LR20) in the appropriate
compartment while observing the polarities indicated
on the device.
Battery replacement
- unhook the battery compartment cover placed on the
bottom of the appliance
- remove the battery and replace observing the polarities
indicated on the device.
ATTENTION!!
Used batteries can not be dispersed in the
environment. Used batteries can not be utilized.
WARNING!!
Water with a temperature higher than 50°
cause serious burns.
Always verify water temperature before
use.
WARNING!!
The casing can reach high temperatures in
the area of the burner.
Ignition procedure
- ensure that the cock located on the cold water fitting is
open
- ensure that the gas cock is open
- make sure the batteries provided (1.5V LR20) were
correctly inserted.
- Turn the knobs between the positions of minimum and
maximum.
The device is ready to operate
By opening a tap, the device automatically starts
operating.
Note:
If the device does not operate, ensure that the gas
and/or cold water cocks are open.
Ensure that the device is electrically powered.
Make sure the batteries were inserted.
When closing the tap, the device automatically switches
off.