Ariston Chaffoteaux 3318905, Инструкция по установке и эксплуатации

Страница: 38 / 116

38
GB
start-up
In order to facilitate the solar parameter
setting operations, without accessing the
complete Menu, it is possible to perform
the confi guration through the rapid access
menu.
Turn the knob and select:
- BRIDGENET BUS NETWORK SETTINGS
Press the OK button.
The display will show the list of devices
present in the system:
- System interface (local)
- Solar control
- ...
- Confi rm components
The confi gurable devices are marked by the
“
” symbol.
To select the hydraulic circuit diagram and
Warning
To ensure the safety and correct operation
of the module, the latter must be started-
up by a legally qualifi ed and authorised
technician.
Ignition procedure
- Power up the module.
- Remove the cover of the control unit con-
nection shoe.
- Insert the system interface into the con-
nection shoe by pushing it gently down-
wards; after a brief initialisation, the sys-
tem interface will be connected.
- The display will show Error 214 “hydraulic
circuit diagram not defi ned”.
- Simultaneously press the back “ ” and
“OK” buttons until “Insert code” appears
on the display.
- Turn the knob to enter the technical code
(234) then press OK; the display will show
TECHNICAL AREA:
- Language, date and time
- BridgeNet Bus network settings
- Complete menu
- Confi guration Wizard
- Service
- Faults
type of pump unit, turn the knob and select:
- Solar control
Press the OK button.
Turn the knob and select the type of indi-
rect cylinder used, from the following:
- - -
Press the OK button.
- Type of pump unit
Turn the knob and select:
- Digital
The display will visualise the type of hy-
draulics diagram used.
Turn the knob and select:
- Confi rm components
Press OK if the list of installed components
is complete, otherwise verify the connec-
tions of the devices not appearing in the list.
Press OK to confi rm the choice, or press
the back button “
“ to return to the previ-
ous visualisation.
To confi gure the peripherals, turn the knob
and select:
- CONFIGURATION WIZARD:
Press the OK button.
Turn the knob and select:
- Solar controller
Press the OK button.
Turn the knob and select from the following:
- Confi guration parameters
- Guided procedures
- Test mode
Turn the knob and select:
- CONFIGURATION PARAMETERS
(allows for visualising and setting the es-
sential parameters for the system's correct
operation)
Press the OK button.
- Solar confi guration
Press the OK button.
Turn the knob and select:
- 3 2 0 Thermal cleanse function
Turn the knob to set the thermal claeanse
function disease function: